Tire & Wheel Overhaul Procedure
- Inspect tread depth and sidewalls for cracks or damage
- Replace worn tires and inspect rims for defects
- Repack and lubricate wheel bearings thoroughly
- Perform wheel alignment and balancing
Fluid System Complete Service Procedure
- Change all fluids: engine oil, hydraulic, brake, transmission, coolant
- Flush systems to remove contaminants
- Replace fluid filters and check for leaks
- Document fluid service dates and next due intervals
Mast & Fork Major Inspection Procedure
- Disassemble mast for thorough inspection and cleaning
- Lubricate all moving parts and replace worn bushings/pins
- Check lift chains, carriage, and forks for cracks and proper alignment
- Verify mast movement under load conditions
Brake & Safety System Certification Procedure
- Replace brake pads, shoes, and inspect hydraulic lines
- Test service and parking brake operation fully
- Inspect all safety decals, load plates, and emergency systems
- Certify full compliance with OSHA and ISO safety standards
Engine, Exhaust, & Cooling System Refurbishment Procedure
- Perform engine compression test and tune-up
- Replace air filters, belts, and coolant system components
- Inspect exhaust for leaks, corrosion, or blockage
- Clean radiator and ensure proper airflow and fan operation
Electrical & Transmission System Renewal Procedure
- Test alternator, battery capacity, and replace if required
- Inspect wiring harnesses, fuses, and electrical connections
- Perform transmission fluid replacement and operational test
- Evaluate drivetrain, clutches, and drive axles for wear and vibration